GroClone PRODUCT INFORMATION

GroClone is NOT just another knock-off of other cloning units already on the market. It IS NOT an airoponic system or a bubbler system. GroClone IS a new and innovative approach to cloning plants that provides a tremendous amount of oxygen in a form that is readily usable by the cuttings. It is not complicated because cloning doesn't need to be. Simply put, it supplies what a cutting needs to develop roots. . 

GroClone was designed to provide these 4 basic requirements:

1)	RELIABILITY - GroClone can be used in temperature ranges that can be problematic for other cloning techniques. GroClone is designed to minimize the absorption of surface temperatures and the unit’s small water pump adds virtually no additional heat to the reservoir so the units maintain a temperature that is only 3-5 degrees over ambient temperature. It has been tested in temperature ranges of up to 85 degrees constant room temperature and in varying temperatures of 75 to 93 degrees with 100% success in 3-8 days.
2)	ENERGY EFFICIENCY – The GroClone reservoir holds only two gallons of water and under most conditions water does not need to be replenished or changed during the rooting cycle. The small .09 amp pump provides minimal electricity needs and is adapted to serve double duty as an oxygen infuser, which eliminates the need for any additional air pumps or bubble stones.
3)	SIMPLICITY – GroClone is specifically designed to create an ideal rooting environment by providing an abundance of continuously diffused fresh oxygen throughout the water reservoir. This unique method needs no monitoring and allows the plant cuttings to thrive. It results in a high continuous success rate of healthy root formation without all the headaches associated with other techniques. GroClone does not require the use of a dome and all indicated results have been without the use of supplemental additives.
4)	COMPACTIBILITY – GroClone provides 53 cutting sites in a small 12x24x4”unit and fits under any standard 2’ lighting fixture which makes it a perfect tabletop unit. To maximize sites 2 units fit side by side under a single 4’ fixture providing a capacity for 106 cuttings. The unit requires only two gallons of water and weighs only 13 lbs. while in operation and can be easily moved when full.

There are many different ways to root cuttings or clone plants. However, the problem with most of them is they operate on strict environmental control guidelines with tedious monitoring and as a result an individual needs a strong knowledge of cuttings. Some of these techniques would include the need for high humidity, conducive to molds, along with tedious watering. Other techniques use large water pumps in the reservoir that have a tendency to overheat the water and as a result increase the incidence of stem rot because of lack of oxygen around the stem, which make these techniques more sensitive to warmer external temperatures.

Darren P. Designer -

“I've been cloning for 20 years. The reason I designed this product is because I personally have spent a lot of valuable time and money through trial and error with different techniques. I wasn't getting the consistent results I expected or wanted from other cloning techniques. This led to designing the groClone system, which has met and exceeded my expectations. .” I honestly do not believe you'll find a better cloning system on the market that will give you these results." GroClone